When the burner heads and caps are dry, replace them in their proper positions, plug in the unit, and try lighting the burners again. Take the burner heads and caps, shake off any excess water, and thoroughly dry them by air drying or by placing them in a warm oven for 30 minutes.The good news is this issue can be quickly resolved by following the steps below Solution/s When Whirlpool gas stove does not work after cleaning, it is usually because the burner or burners are wet or dirty, the electrode is not properly seated, or the burner head and cap are not properly matched up. Whirlpool Gas Stove Not Working After Cleaning If this doesn’t work, there could be a kink in the gas supply line or a larger problem, in which case you should contact a professional. If the igniter sparks yellow or orange rather than a bright bluish-white, you should probably replace it. You can quickly determine whether the igniter needs to be replaced by turning the control knob to the ignite position and turning out the lights in the area.Finally, still not igniting you may have a defective igniter if you have cleaned the burner base of any debris and tightened any loose connections.Reconnect the stove and try lighting the burner again. Reinstall the burner base, cap, and grate after securing any loose connections and reconnecting any disconnected wires. Check for loose connections or disconnected wires after removing the sealed burner base. Remove the grate and the burner cap from the faulty burner. First, turn off the power to the appliance by unplugging it from the wall or turning off the breaker.If the wires connecting the igniter to the control module are not securely connected, you will not receive the spark required to properly ignite the burner. If the stove still does not light, it is possible that connections have become loose, especially during cleaning or installation.Once completely dried reinstall the burner, cover, and grill, and try lighting the burner again. Next use a toothpick, sewing needle, or compressed air to clean any remaining debris from the burner holes.Soak the sealed burner base in vinegar or warm water and brush away any debris with a stiff brush. With a warm, soapy washcloth, clean the surrounding area.Use soapy water to thoroughly clean the grease and grime off the stove and burners Remove the burner cap, which should come off easily. Still not igniting the next step is to remove the grate that is covering the troubled burner.Your gas stove won’t be able to ignite if the burner caps are not in the right position. Next step is to check that the correct burner cap is on the correct head and that the correct head is on the correct burner.Replace a blown fuse or switch a tripped breaker to the “On” position. In the circuit breaker or fuse box in your home, check the fuse or circuit breaker for the stove.The reason being most ignitors need electricity to operate. But before you do anything, check to make sure the stove is plugged into a power socket, a socket that works.The steps listed below should be carefully followed to solve this problem. Whirlpool gas stove not clicking, sparking, or turning on is usually caused by a build-up of food debris, grease, water, or a faulty ignitor. When you start a burner and don’t hear the clicking sound of a spark jumping from the igniter electrode to the burner head, it’s because the gas stove igniter isn’t sparking. When you turn the knob on a gas stove cooktop to the “light” position, a surface burner igniter switch and a spark module activate the spark electrode. 11 References Whirlpool Gas Stove Not Turning On.2 Whirlpool Gas Stove Not Working After Cleaning.

Whirlpool gas range